IBM System x3300 M4 Installation And Service Manual page 394

To remove the system-board battery, complete the following steps:
1. Read the safety information that begins in Safety and "Installation guidelines"
2. Turn off the server (see "Turning off the server" on page 24) and all attached
3. Disconnect all external cables and power cords.
4. Carefully turn the server on its side so that it is lying flat, with the cover facing
376
System x3300 M4 Type 7382: Installation and Service Guide
Statement 2
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has
a module containing a lithium battery, replace it only with the same module
type made by the same manufacturer. The battery contains lithium and can
explode if not properly used, handled, or disposed of.
Do not:
– Throw or immerse into water
– Heat to more than 100°C (212°F)
– Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
on page 36.
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
up.