Removing The Bezel (Rack Model); Removing The Bezel (Tower Model) - IBM eServer xSeries 255 Option Installation Manual

Removing the bezel (rack model)

Before you can install any removable-media drives in a rack model server, you must
first remove the bezel.
Complete the following steps to remove the rack model bezel.
1. Press on the two release latches at the top edge of the bezel, and pull the top
2. Lift the bezel to release the two tabs at the bottom edge of the bezel.
3. Store the bezel in a safe place.

Removing the bezel (tower model)

Before you can access the controls on the front of a tower model server or install
any internal drives in a tower model server, you must first remove the bezel.
16
IBM xSeries 255 Type 8685: Option Installation Guide
of the bezel slightly away from the server.