Replacing The Air Baffle - IBM System x3300 M4 Installation And Service Manual

Replacing the air baffle

Note: When you install the second microprocessor, you must also install fan 2 and
the air baffle that come with the second microprocessor upgrade kit.
To replace the air baffle, complete the following steps:
1. Read the safety information that begins in Safety and "Installation guidelines"
2. Turn off the server (see "Turning off the server" on page 24) and all attached
3. Remove the left-side cover (see "Removing the left-side cover" on page 39).
4. Remove the existing air baffle (see "Removing the air baffle" on page 41).
5. Touch the static-protective package that contains the air baffle; then, remove the
6. Slide the air baffle down into the server until the tabs fit into the locating holes.
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 104.
336
System x3300 M4 Type 7382: Installation and Service Guide
on page 36.
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
air baffle from the package.