IBM System x3300 M4 Installation And Service Manual page 445

13. Press the microprocessor 2 expansion board firmly and vertically to the
system board.
Note:
v Static electricity that is released to internal server components when the
server is powered-on might cause the server to halt, which might result in
the loss of data. To avoid this potential problem, always use an
electrostatic-discharge wrist strap or other grounding system when you
work inside the server with the power on.
v Make sure that none of the server cables are caught under the
microprocessor 2 expansion board.
14. Rotate the release lever to the close position to secure the microprocessor 2
expansion board in place.
Note: Press the microprocessor 2 expansion board connector to make sure the
connector is seated securely on the system board.
15. Connect the microprocessor 2 power cable (P4) to its connector on the system
board (see"Power Cable Connection" on page 47 ).
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 104.
Chapter 6. Removing and replacing components
427