IBM System x3300 M4 Installation And Service Manual page 224

Table 18. IMM2 error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v If an action step is preceded by "(Trained technician only)," that step must be performed only by a trained
technician.
806f0123-2101xxxx Reboot of system %1
initited by %2. (%1 =
ComputerSystem.ElementName)
(%2 =
Watchdog.ElementName)
806f0125-0c01xxxx Front panel entity
has been detected
Absent.
806f0013-1701xxxx A front panel NMI
has occurred on
system %1. (%1 =
CIM_ComputerSystem.
ElementName)
806f0313-1701xxxx A software NMI has
occurred on system
%1. (%1 =
CIM_ComputerSystem.
ElementName)
806f0823-2101xxxx Watchdog Timer
interrupt occurred
for %1. (%1 =
Watchdog.ElementName)
806f0a13-0301xxxx A Fatal Bus Error
has occurred on
system CPU 1 PECI.
806f0a13-0302xxxx A Fatal Bus Error
has occurred on
system CPU 2 PECI.
81030012-2301xxxx OS RealTime Mod
state has deasserted.
206
System x3300 M4 Type 7382: Installation and Service Guide
Info This message is for
the use case when
an implementation
has detected a
Reboot by a
Watchdog
occurred.
Info A front panel
entity has been
detected absent.
Error An operator
information panel
NMI/diagnostic
interrupt has
occurred.
Error A software NMI
has occurred.
Info This message is for
the use case when
an implementation
has detected a
Watchdog Timer
interrupt occurred.
Error A bus fatal error
has been detected.
Error A bus fatal error
has been detected.
Info OS RealTime Mod
state has
deasserted.
No action; information only.
No action; information only.
1. Check the device driver.
2. Reinstall the device driver.
3. Update all device drivers to the
latest level.
4. Update the firmware (UEFI and
IMM) (see "Updating the firmware"
on page 111).
1. Check the device driver.
2. Reinstall the device driver.
3. Update all device drivers to the
latest level.
4. Update the firmware (UEFI and
IMM) (see "Updating the firmware"
on page 111).
No action; information only.
1. Reseat the microprocessor, and then
restart the server.
2. Replace microprocessor n.
(n = microprocessor number)
1. Reseat the microprocessor, and then
restart the server.
2. Replace microprocessor n.
(n = microprocessor number)
No action; information only.