IBM System x3300 M4 Installation And Service Manual page 372

12. Connect power and signal cables to the drive and the connectors on the
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 104.
Removing an optional tape drive:
To remove an optional full-height tape drive, complete the following steps:
1. Read the safety information that begins in Safety and "Installation guidelines"
2. Turn off the server (see "Turning off the server" on page 24) and all attached
3. Unlock and remove the left-side cover (see "Removing the left-side cover" on
4. Open the bezel (see "Removing the bezel" on page 331)
5. Disconnect power and signal cables to the drive and the connectors on the
6. Remove the air baffle if installed (see "Removing the air baffle" on page 41)
7. Remove the fan assembly (see "Removing the fan assembly" on page 42)
8. Pressing the drive rail on the side of the tape drive and grasp the front of tape
354
System x3300 M4 Type 7382: Installation and Service Guide
system board (see "Internal Cable Routing and Connectors" on page 47).
on page 36.
peripheral devices. Disconnect all power cords; then, disconnect all external
cables from the server.
page 39)
system board (see "Internal Cable Routing and Connectors" on page 47)
drive out of the server.