IBM System x3300 M4 Installation And Service Manual page 227

Table 18. IMM2 error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v If an action step is preceded by "(Trained technician only)," that step must be performed only by a trained
technician.
806f000f-2201ffff The System %1
encountered a POST
Error. (%1 =
ComputerSystem.ElementName)
806f000f-2201xxxx The System %1
encountered a POST
Error.(%1 =
CIM_ComputerSystem.
ElementName)
Error The System ABR
Status / Firmware
Error encountered
a POST Error.
Error The System
encountered a
firmware error.
(Sensor =
Firmware Error)
1. Make sure the server meets the
minimum configuration to start
(see "Power-supply LEDs" on page
21).
2. Recover the server firmware from
the backup page:
a. Restart the server.
b. At the prompt, press F3 to
recover the firmware.
3. Update the server firmware to the
latest level (see "Updating the
firmware" on page 111).
Important: Some cluster solutions
require specific code levels or
coordinated code updates. If the
device is part of a cluster solution,
verify that the latest level of code is
supported for the cluster solution
before you update the code.
4. Remove components one at a time,
restarting the server each time, to
see if the problem goes away.
5. If the problem remains, (trained
technician) replace the system
board.
1. Make sure the server meets the
minimum configuration to start
(see "Power-supply LEDs" on page
21).
2. Update the server firmware on the
primary page.
Important: Some cluster solutions
require specific code levels or
coordinated code updates. If the
device is part of a cluster solution,
verify that the latest level of code is
supported for the cluster solution
before you update the code.
3. (Trained technician only) Replace
the system board.
Chapter 4. Troubleshooting
209