Installing Drives - IBM System x3300 M4 Installation And Service Manual

6. Touch the static-protective package that contains the DIMM to any unpainted
7. Turn the DIMM so that the DIMM keys align correctly with the connector.
8. Insert the DIMM into the connector by aligning the edges of the DIMM with
9. Firmly press the DIMM straight down into the connector by applying pressure
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 104.

Installing drives

The followings are illustrations of the server and the location of the drive bays.
Your hardware might differ, depending on the model.
Note: If the server is configured for RAID operation using a ServeRAID adapter,
you might have to reconfigure your disk arrays after you install drives. See the
ServeRAID adapter documentation for additional information about RAID
operation and complete instructions for using the ServeRAID adapter.
The following illustrations show the location of the drive bays in the 2.5-inch and
3.5-inch hard disk drive server models.
v The server with eight 2.5-inch hard disk drives:
metal surface on the outside of the server. Then, remove the DIMM from the
package.
the slots at the ends of the DIMM connector (see "System-board internal
connectors" on page 29 for the locations of the DIMM connectors).
on both ends of the DIMM simultaneously. The retaining clips snap into the
locked position when the DIMM is firmly seated in the connector.
Note: If there is a gap between the DIMM and the retaining clips, the DIMM
has not been correctly inserted; open the retaining clips, remove the DIMM,
and then reinsert it.
Chapter 2. Installing optional devices
67