Installing The Rear Fan - IBM System x3300 M4 Installation And Service Manual

Installing the rear fan

To install the rear fan, complete the following steps:
1. Read the safety information that begins in "Safety" on page vii and
2. Turn off the server (see "Turning off the server" on page 24) and all attached
3. Carefully turn the server on its side so that it is lying flat, with the cover facing
4. Unlock and remove the left-side cover (see "Removing the left-side cover" on
5. Remove the air baffle (see "Removing the air baffle" on page 41).
6. Touch the static-protective package that contains the fan to any unpainted
7. Locate the rear fan position of the server chassis (see step 1 in the following
8. Insert two tabs of the rear fan into the holes of the server chassis, and rotate
9. Connect the rear fan power cable on the system board. (see "Internal Cable
106
System x3300 M4 Type 7382: Installation and Service Guide
"Installation guidelines" on page 36.
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
up.
Attention: Do not allow the server to fall over.
page 39).
metal surface on the server; then, remove the fan from the package.
illustration).
the rear fan to click into the server chassis (see step 1 in the following
illustration).
Routing and Connectors" on page 47).