Removing An Adapter - IBM System x3300 M4 Installation And Service Manual

12. Reinstall the bezel (see "Removing the bezel" on page 331
13. Reinstall the left-side cover (see "Removing the left-side cover" on page 39
14. Reconnect the power cords and any cables that you removed.
15. Turn on the peripheral devices and the server.

Removing an adapter

To remove an adapter, complete the following steps:
358
System x3300 M4 Type 7382: Installation and Service Guide
1. Read the safety information that begins in Safety and "Installation guidelines"
on page 36.
2. Turn off the server (see "Turning off the server" on page 24) and all attached
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
3. Carefully turn the server on its side so that it is lying flat, with the cover
facing up.
Note: Do not allow the server to fall over.
4. Unlock and remove the left-side cover (see "Removing the left-side cover" on
page 39).
5. Remove the air baffle (see "Removing the air baffle" on page 41).
6. Remove the fan assembly (see "Removing the fan assembly" on page 42).
7. Disconnect any cables from the adapter.
8. Press down the release latch from the rear of the server to move forward the
adapter-retention brackets to the open position.