IBM System x3300 M4 Installation And Service Manual page 206

Table 18. IMM2 error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v If an action step is preceded by "(Trained technician only)," that step must be performed only by a trained
technician.
806f0813-2584xxxx An Uncorrectable
Bus Error has
occurred on system
%1.(%1 =
CIM_ComputerSystem.
ElementName)
Memory errors
806f000f-220101xx The System %1 has
detected no memory
in the system. (%1 =
CIM_ComputerSystem.ElementName)
806f000f-220102xx Subsystem %1 has
insufficient memory
for operation. (%1 =
CIM_Memory.ElementName)
188
System x3300 M4 Type 7382: Installation and Service Guide
Error A bus
uncorrectable error
has occurred.
(Sensor = Critical
Int CPU)
Error This message is for
the use case when
an implementation
has detected that
memory was
detected in the
system.
Error This message is for
the use case when
an implementation
has detected that
the usable Memory
is insufficient for
operation.
1. Check the system-event log.
2. (Trained technician only) Remove
the failing microprocessor from the
system board (see "Removing a
microprocessor and heat sink" on
page 416).
3. Check for a server firmware update.
Important: Some cluster solutions
require specific code levels or
coordinated code updates. If the
device is part of a cluster solution,
verify that the latest level of code is
supported for the cluster solution
before you update the code.
4. Make sure that the two
microprocessors are matching.
5. (Trained technician only) Replace
the system board (see "Removing
the system board" on page 428 and
"Replacing the system board" on
page 430).
1. This is a UEFI detected event. The
UEFI diagnostic code for this event
can be found in the logged IMM
message text. Please refer to the
UEFI diagnostic code in the "UEFI
diagnostic code" section of the Info
Center for the appropriate user
response.
1. This is a UEFI detected event. The
UEFI diagnostic code for this event
can be found in the logged IMM
message text. Please refer to the
UEFI diagnostic code in the "UEFI
diagnostic code" section of the Info
Center for the appropriate user
response.