IBM System x3300 M4 Installation And Service Manual page 37

v PCI-e slot 2: Insert a full-length, full-height PCI Express adapter into this slot.
See "Installing an adapter" on page 79 for information about adapters that this
riser card support.
v PCI-e slot 3: Insert a half-length, full-height PCI Express adapter into this slot.
See "Installing an adapter" on page 79 for information about adapters that this
riser card support.
v PCI-e slot 4: Insert a full-length, full-height PCI Express adapter into this slot.
See "Installing an adapter" on page 79 for information about adapters that this
riser card support.
v PCI-e slot 5: Insert a half-length, full-height PCI Express adapter into this slot.
See "Installing an adapter" on page 79 for information about adapters that this
riser card support.
v PCI-e slot 6: Insert a half-length, full-height PCI Express adapter into this slot.
See "Installing an adapter" on page 79 for information about adapters that this
riser card support.
Note: It has PCI-X capability by using PCI-e to PCI-X converter kit of IBM
System x3500 M4 Type 7383.
v Power connector: Connect the power cord to this connector.
v Video connector: Connect a monitor to this connector.
Note: The maximum video resolution is 1600 x 1200 at 75 Hz.
v Serial connector: Connect a 9-pin serial device to this connector. The serial port
is shared with the Integrated Management Module II (IMM2). The IMM2 can
take control of the shared serial port to redirect serial traffic, using Serial over
LAN (SOL).
v USB connectors: Connect a USB device, such as a USB mouse or keyboard to
any of these connectors.
v Ethernet connectors: Use either of these connectors to connect the server to a
network.
The following illustrations show the LEDs on the rear of the server.
Chapter 1. The IBM System x3300 M4 Type 7382 server
19