Lucent Technologies DEFINITY User Manual page 26

Installation
If you are using a DCP telephone and PassageWay Adapter (see
Figure 1-5):
1. Plug the EIA-232-D Connector cord (including adapter, if
necessary) into the communications (COM) port on the PC. If more
than one port is available, write down the number of the port to
which you physically attach the cord. Tighten all retaining screws.
2. Plug the remaining end of the EIA-232-D Connector cord (including
adapter, if necessary) into the 9-pin interface on the PassageWay
Adapter. Tighten all retaining screws.
3. Connect one end of a D8W cord to the " Phone" jack on the
PassageWay Adapter. Connect the other end to the jack on the
DCP telephone.
4. Connect one end of another D8W cord to the " Line" jack on the
PassageWay Adapter. You will use the remaining end of this cord
to connect to the power source. Turn to the section entitled
" Connecting the PC/Telephone Configuration to the Power Source."
1-12
Issue 2.5 October 1999
NOTE:
Attach an adapter only if the EIA-232-D Connector cord does
not conform to the COM port on the PC. You can purchase
adapters to change the number of pins and/or the gender of
the connector.
NOTE:
Attach an adapter only if the EIA-232-D Connector cord does
not conform to the 9-pin female interface on the PassageWay
Adapter. You can purchase adapters to change the number
of pins and/or the gender of the connector.