Configuring The Maximum Number Of Attempts To Send An Ns Message For Dad - HP FlexNetwork MSR2003 Configuration Manual

Step
4. Turn off the MTU option in
RA messages.
5. Specify unlimited hops in
RA messages.
6. Set the M flag bit to 1.
7. Set the O flag bit to 1.
8. Configure the router
lifetime in RA messages.
9. Set the NS retransmission
timer.
10. Set the router preference
in RA messages.
11. Set the reachable time.
Configuring the maximum number of attempts to send an NS
message for DAD
An interface sends an NS message for DAD for an obtained IPv6 address. The interface resends the
NS message if it does not receive a response within the time specified by the ipv6 nd ns
retrans-timer command. If the interface receives no response after making the maximum attempts
specified by the ipv6 nd dad attempts command, the interface uses the IPv6 address.
To configure the attempts to send an NS message for DAD:
Step
1. Enter system view.
2. Enter interface view.
3. Configure the number of
attempts to send an NS
Command
[ no-autoconfig | off-link ] *
ipv6 nd ra no-advlinkmtu
ipv6 nd ra hop-limit
unspecified
ipv6 nd autoconfig
managed-address-flag
ipv6 nd autoconfig other-flag
ipv6 nd ra router-lifetime
value
ipv6 nd ns retrans-timer
value
ipv6 nd router-preference
{ high | low | medium }
ipv6 nd nud reachable-time
value
Command
system-view
interface interface-type
interface-number
ipv6 nd dad attempts value
218
Remarks
information. If the IPv6 address is
manually configured, the prefix uses a
fixed valid lifetime of 2592000 seconds
(30 days) and a preferred lifetime of
604800 seconds (7 days). If the IPv6
address is automatically obtained, the
prefix uses the valid lifetime and
preferred lifetime configured for the
IPv6 address.
By default, RA messages contain the
MTU option.
By default, the maximum number of
hops in RA messages is 64.
By default, the M flag bit is set to 0 in
RA advertisements. Hosts receiving the
advertisements will obtain IPv6
addresses through stateless
autoconfiguration.
By default, the O flag bit is set to 0 in
RA advertisements. Hosts receiving the
advertisements will acquire other
configuration information through
stateless autoconfiguration.
By default, the router lifetime is 1800
seconds.
By default, an interface sends NS
messages every 1000 milliseconds,
and the value of the Retrans Timer field
in RA messages is 0.
By default, the router preference is
medium.
By default, the neighbor reachable time
is 30000 milliseconds, and the value of
the Reachable Time field in sent RA
messages is 0.
Remarks
N/A
N/A
The default setting is 1. When the
value argument is set to 0, DAD is