Viewing Backup Configurations and Troubleshooting Backup Connections
Table 3-11. Backup LEDs
Color
Meaning
off
The backup interface has not been activated.
red
The backup interface is down.
solid green
The backup interface is up and ready to provide a connection.
flashing green
The backup interface is active and providing the current connection.
Viewing the Status and Configuration of Backup Interfaces
After you configure backup support, you should verify that the BRI or modem
interface is ready to provide the backup connection, and you should double-
check the configuration. For BRI interfaces, you should ensure that the BRI
interface has been configured with the correct settings for the ISDN switch
(signaling) type, LDN, and SPID (if one is required). If you are using demand
routing, you should also ensure that the BRI or modem interface has been
assigned to a resource pool.
View the Status of the BRI Interface. To check the configuration and the
status of the BRI interface, enter the following command from the enable
mode context:
Syntax: show interfaces bri <slot>/<port>
You can also add do to access the commands from any mode context. For
example, you can view the status of a BRI interface while configuring that
interface by entering:
ProCurve(config-bri 1/2)# do show interface bri 1/2
Configuring Backup WAN Connections
3-73