Cli: Viewing Port Status And Configuring Port Parameters - HP ProCurve 6400cl Series Management And Configuration Manual

Port Status and Basic Configuration
Viewing Port Status and Configuring Port Parameters
10-8
CLI: Viewing Port Status and Configuring Port
Parameters
Port Status and Configuration Commands
show interfaces brief
show interfaces config
interface
disable/enable
speed-duplex
flow-control
broadcast-limit
auto-mdix
From the CLI, you can configure and view all port parameter settings and view
all port status indicators.
Using the CLI To View Port Status. Use the following commands to dis­
play port status and configuration.
Syntax: show interfaces [ brief | config | < port-list >]
brief: Lists the current operating status for all ports on the
switch.
config: Lists a subset of configuration data for all ports on the
switch; that is, for each port, the display shows whether the port
is enabled, the operating mode, and whether it is configured
for flow control.
< port-list >: Shows a summary of network traffic handled by the
specified ports.
Series 3400cl and Series 6400cl switches include per-port
broadcast limit settings in the show interfaces and show
interfaces brief display outputs.
The next two figures list examples of the output of the above two command
options for the same port configuration.
page 10-9
page 10-9
page 10-9
page 10-9
page 10-9
page 10-11
page 10-14
page 10-15