Configuring A Layer 2 Ethernet Interface; Layer 2 Ethernet Interface Configuration Task List; Configuring A Port Group - HP HSR6800 Configuration Manual

Interface

Hide thumbs Also See for HSR6800:

Table of Contents

Step

Enter Ethernet interface view.

Enable subinterface rate

statistics collection on the

Ethernet interface.

Configuring a Layer 2 Ethernet interface

The features in this section are supported on only SAP modules that are operating in bridge mode.

You can perform the following configurations on Ethernet interfaces operating in bridge mode.

Task

Setting speed options for auto negotiation on an Ethernet

interface

Configuring storm suppression

Configuring jumbo frame support

Enabling loopback detection on an Ethernet interface

Setting the MDI mode of an Ethernet interface

Testing the cable connection of an Ethernet interface

Configuring storm control on an Ethernet interface

Configuring a port group

Some interfaces on your device might use the same set of settings. To configure these interfaces in bulk

rather than one by one, you can assign them to a port group.

You create port groups manually. All settings made for a port group apply to all member ports of the

group. For example, you can configure a traffic suppression threshold (see

suppression") for multiple interfaces in bulk by assigning these interfaces to a port group.

Command

interface interface-type

interface-number

sub-interface rate-statistic

Remarks

Optional.