ZyXEL Communications MGS3600-24F User Manual page 303

F M
RONT ATTER
The number of RADIUS packets that were received with unknown types from the server on the authentication port and dropped.
Packets Dropped:

The number of RADIUS packets that were received from the server on the authentication port and dropped for some other reason.
Access Requests:

The number of RADIUS Access-Request packets sent to the server. This does not include retransmissions.
Access Retransmissions:

The number of RADIUS Access-Request packets retransmitted to the RADIUS authentication server.
Pending Requests:

The number of RADIUS Access-Request packets destined for the server that have not yet timed out or received a response. This variable is
incremented when an Access-Request is sent and decremented due to receipt of an Access-Accept, Access-Reject, Access-Challenge,
timeout, or retransmission.
Timeouts:

The number of authentication timeouts to the server. After a timeout, the client may retry to the same server, send to a different server, or
give up. A retry to the same server is counted as a retransmit as well as a timeout. A send to a different server is counted as a Request as
well as a timeout.
State:

The current state of the server. This field takes one of the following values:
Disabled: The server is disabled.

Not Ready: The server is enabled, but IP communication is not yet up and running.

Ready: The server is enabled, IP communication is up and running, and the RADIUS module is ready to accept accounting attempts.

Dead (X seconds left):

The server has temporarily been disabled, but will get re-enabled when the dead-time expires. The number of seconds left before this
occurs is displayed in parentheses. This state is only reachable when more than one server is enabled.
Round-Trip Time:

The time interval (measured in milliseconds) between the most recent Access-Reply/Access-Challenge and the Access-Request that
matched it from the RADIUS authentication server. The granularity of this measurement is 100 ms. A value of 0 ms indicates that there
hasn't been round-trip communication with the server yet.
MGS3600-24F/XGS3600-26F/XGS3600-28F
Accounting/Authentication attempts were made to this server, but it did not reply within the configured timeout.
8-30 U ' G
SER S UIDE