ZyXEL Communications MGS3600-24F User Manual page 151

F M
RONT ATTER
Use these drop-down boxes to configure which sender protocol address and target protocol address field values match this ACE. Choose
Any to configure this ACE to ignore the sender/target protocol address field. Choose
Target IP Address field to match a specific sender or target protocol address. Choose
or Target IP Address
ARP SMAC Match

Use this drop-down box to configure the ACE to compare the sender hardware address in the ARP header against the source Ethernet
address in the Ethernet frame's header. Choose
ACE if the addresses are not equal or choose
RARP DMAC Match

Use this drop-down box to configure the ACE to compare the target hardware address in the RARP header against the destination Ethernet
address in the Ethernet frame's header. Choose
ACE if the addresses are not equal or choose
IP/Ethernet Length

Use this drop-down box to configure the ACE to check if the hardware address length is 6 bytes (Ethernet MAC address length) and the
protocol address length is 4 bytes (IPv4 address length). Choose
match in the ACE if the check is not successful or choose
IP

Use this drop-down box to configure the ACE to check if the hardware address space in ARP/RARP frames is Ethernet. Choose
configure this ACE to ignore the check. Choose
match in the ACE if the check is successful.
Ethernet

Use this drop-down box to configure the ACE to check if the protocol address space in ARP/RARP frames is 0x800 (IPv4). Choose
configure this ACE to ignore the check. Choose
match in the ACE if the check is successful.
IP Parameters
IP Protocol Filter

Use this drop-down box to configure which protocol in the IP header matches this ACE. Choose
protocol. Choose ICMP,
MGS3600-24F/XGS3600-26F/XGS3600-28F
and Sender IP Mask or Target IP Mask
Any
1 to register a match in the ACE if the addresses are equal.
Any
1 to register a match in the ACE if the addresses are equal.
0 to register a match in the ACE if the check is not successful or choose
0 to register a match in the ACE if the check is not successful or choose
UDP or TCP or choose Other
fields to match all sender/target protocol addresses within a network.
to configure this ACE to ignore the comparison. Choose
to configure this ACE to ignore the comparison. Choose
Any to configure this ACE to ignore the check. Choose
1 to register a match in the ACE if the check is successful.
and then complete the IP Protocol Value
7-18
Host and then complete the
Network and then complete the
0 to register a match in the
0 to register a match in the
Any to configure this ACE to ignore the
field match another protocol.
Sender IP Address or
Sender IP Address
0 to register a
Any to
1 to register a
Any to
1 to register a
U ' G
SER S UIDE