A domain is a section of a network that is under the responsibility of a single organization. MEPs are points in devices that participate in CFM at the
edges of domains. Each domain has a maintenance level, so multiple domains may exist on the same device, provided the maintenance level is
unique.
To configure the Ethernet OAM
1. Click
Configuration
>
2. Click
Add new
MEP.
3. Configure the parameters.
4. Click Save.
Parameter description
Instance:
Use this field to configure the identity of the MEP.
Domain:
Use this drop-down box to configure the CFM domain. Possible values are:.
Port:
This is an MEP in the Port Domain. The Flow Instance is a Port.
Esp:
This is reserved for future use and needs a firmware upgrade to support it.
Evc:
This is an MEP in the EVC Domain. The Flow Instance is an EVC.
Mpls:
This is reserved for future use and needs a firmware upgrade to support it.
Mode:
Use this drop-down box to configure this maintenance point as a
Direction:
Use this drop-down box to configure whether this maintenance point monitors