ZyXEL Communications MGS3600-24F User Manual page 100

F M
RONT ATTER
Table 5-5: Configuration > Port > Configuration
L
ABEL
Port
Link
Current Link Speed
Configured Link Speed
Flow Control
Maximum Frame Size
Excessive Collision Mode
MGS3600-24F/XGS3600-26F/XGS3600-28F
This field shows the port number for this row.
This field shows the current link state. Green indicates the link is up and red that it is
down.
This field shows the current link speed.
Use this drop-down box to select a fixed link speed.
Check the Configured column to use pause frames for flow control. The Current Rx col-
umn indicates whether pause frames on the port are obeyed, and the Current Tx column
indicates whether pause frames on the port are transmitted. If the configured link speed is
auto, the current Rx and Tx fields show the flow control capabilities of the link partner. If
the configured link speed is fixed, the current Rx and Tx fields reflect that setting. The cur-
rent Rx and Tx settings are determined by the result of the last Auto-Negotiation. Flow
control is not possible for half duplex (HDX) link speeds.
Use this field to configure the maximum frame size, including Frame Check Sequence
(FCS) allowed for the port.
Use this drop-down box to configure port transmit collision behavior. Possible collision
modes are:
Discard: Discard frame after 16 collisions (default).

Restart: Restart backoff algorithm after 16 collisions.

5-17
D
ESCRIPTION
U ' G
SER S UIDE