ZyXEL Communications MGS3600-24F User Manual page 153

F M
RONT ATTER
TCP Parameters
Source Port Filter and

Use these drop-down boxes to configure which TCP source port and TCP destination port field values match this ACE. Choose
this ACE to ignore the source/destination port field. Choose
specific source or destination port. Choose
source or destination ports.
TCP FIN, TCP SYN, TCP

Use these drop-down boxes to configure the ACE to check if the FIN (finish), SYN (sychronize), reset (RST), push (PSH), acknowledge (ACK)
and urgent (URG) TCP control flags are set. Choose
choose 1 to register a match in the ACE if the flag is set.
ACE Actions
Action:

Use this drop-down box to
Rate Limiter:

Use this drop-down box to apply a rate limiter ID if the ACE matches. Choose
iter.
Port Copy:

Use this drop-down box to apply copy traffic to another port if the ACE matches. Choose
to copy traffic.
Logging:

Use this drop-down box to log traffic in the system log if the ACE matches. Choose
fic.
Note:
The system log memory and logging rate is limited.
Shutdown:

Use this drop-down box to shutdown the ingress port(s) if the ACE matches. Choose
down port(s).
Counter:

This field shows the number of frames that have matched the ACE.
MGS3600-24F/XGS3600-26F/XGS3600-28F
Dest. Port Filter
Range and then complete the
RST, TCP PSH, TCP ACK
Any
Permit (default) or Deny forwarding of traffic that matches the ACE.
Specific and then complete the
Source Port Range
and TCP URG
to configure this ACE to ignore the check. Choose
Disabled
Disabled
Disabled
7-20
Source Port No. or Dest. Port No.
or Dest. Port Range field to match a range of
0 to fail the ACE if the flag is set or
to disable this action or choose
Disabled to disable this action or choose a port number
to disable this action or choose
to disable this action or choose
Any to configure
field to match a
1 to 16 to apply a rate lim-
Enabled to log traf-
Enabled to shut-
U ' G
SER S UIDE