ZyXEL Communications MGS3600-24F User Manual page 245

F M
RONT ATTER
Use this drop-down box to configure which Ethernet Length/Type field values match this QCE. Choose
frames with an Ethernet Length/Type field of 0x0600 to 0xFFFF excluding 0x0800 (IPv4) and 0x86DD (IPv6). Choose
complete the Ethernet Type Value
0x0800 (IPv4) or 0x86DD (IPv6) cannot be configured.
LLC Parameters
SSAP Address:

Use this drop-down box to configure which Source Service Access Point (SSAP) address matches this QCE. Choose
QCE to ignore the SSAP. Choose
DSAP Address:

Use this drop-down box to configure which Destination Service Access Point (DSAP) address matches this QCE. Choose
this QCE to ignore the DSAP. Choose
Control:

Use this drop-down box to configure which control address matches this QCE. Choose
address. Choose Specific
SNAP Parameters
PID:

Use this drop-down box to configure which Protocol ID matches this QCE. Choose
Specific and then complete the
IPv4 Parameters
Protocol:

Use this drop-down box to configure which protocol in the IP header matches this QCE. Choose
protocol. Choose UDP
Source IP:

Use this drop-down box to configure which source IP address field values matches this QCE. Choose
the source IP address field. Choose
work.
MGS3600-24F/XGS3600-26F/XGS3600-28F
field to match a specific Ethernet Length/Type. Ethernet Type Values less than 0x0600 or equal to
Specific and then complete the
Specific and then complete the
and then complete the Value
Value field to match a specific PID from 0 to 0xFFFF.
or TCP or choose Other and then complete the
Specific and then complete the
Value field to match a specific SSAP from 0 to 0xFF.
Value field to match a specific DSAP from 0 to 0xFF.
field to match a specific control address from 0 to 0xFF.
Any
IP Protocol Value
Value and Mask
7-112
Any to configure this QCE to match
Any to configure this QCE to ignore the control
to configure this QCE to ignore the PID. Choose
Any to configure this QCE to ignore the
field match another protocol.
Any to configure this QCE to ignore
fields to match all source IP addresses within a net-
Specific and then
Any to configure this
Any to configure
U ' G
SER S UIDE