ZyXEL Communications MGS3600-24F User Manual page 246

F M
RONT ATTER
IP Fragment:

Use this drop-down box to configure this QCE to match the IPv4 fragmented flag.
DSCP:

Use this drop-down box to configure this QCE to match the DSCP.
UDP and TCP Parameters
SPort and DPort

Use these drop-down boxes to configure which TCP/UDP source port and TCP/UDP destination port field values match this QCE. Choose
Any to configure this QCE to ignore the source/destination port field. Choose
source or destination port. Choose
IPv6 Parameters
Protocol:

Use this drop-down box to configure which protocol in the IP header matches this QCE. Choose
protocol. Choose UDP
Source IP (32 LSB):

Use this drop-down box to configure which least significant 32-bits of source IP address field values matches this QCE. Choose
figure this QCE to ignore the source IP address field. Choose
addresses within a network.
DSCP:

Use this drop-down box to configure this QCE to match the DSCP.
QCE Actions
Class:

Use this drop-down box to configure which queue frames are put in if this QCE is triggered.
DPL:

Use this drop-down box to configure which drop precedence level is set if this QCE is triggered.
DSCP:

Use this drop-down box to configure which DSCP is set if this QCE is triggered.
MGS3600-24F/XGS3600-26F/XGS3600-28F
Range and then complete the
or TCP or choose Other and then complete the
Specific and then complete the
From and To fields to match a range of source or destination ports.
IP Protocol Value
Specific and then complete the
7-113
Value field to match a specific
Any to configure this QCE to ignore the
field match another protocol.
Value and Mask fields to match all source IP
Any to con-
U ' G
SER S UIDE