Trap - ZyXEL Communications MGS3600-24F User Manual

F M
RONT ATTER

6.7.7 Trap

Use the Trap sub-menu to configure the SNMP trap table. The maximum number of traps is 6.
To configure an SNMP Trap:
1. Click System > SNMP
2. Click an entry number to display or modify it.
3. Specify the Trap parameters.
4. Click Save.
Parameters description:
Delete:

Use this check box to mark an entry for deletion. The entry is deleted during the next save.
Trap Version:

Use this drop-down box to configure an SNMP v2c or v3 trap.
Server IP:

Use this field to configure the IP address of the host that will receive the trap.
UDP Port:

Use this field to configure the UDP port number that traps are sent to. The default is port is 162.
Community / Security Name:

Use this field to configure an SNMPv3 community access string. Community strings can be up to 32 characters, each of which with ASCII
codes from 33 to 126. The community string is treated as a security name and mapped to an SNMPv1 or SNMPv2c community string.
Severity Level:

Use this drop-down box to configure the severity level of the messages that are sent as traps. Possible levels are: Emergency, Alert, Criti-
cal, Error, Warning, Notice, Informational and Debug.
Security Level:

Use this drop-down box to configure the security level of a new entry. Possible security levels are:
NoAuth, NoPriv:

MGS3600-24F/XGS3600-26F/XGS3600-28F
> Trap to display the SNMP Trap Hosts Configuration table.
No authentication and no privacy.
6-31 U ' G
SER S UIDE