Dell PowerConnect B-FCXs Configuration Manual page 1438

41
Syslog messages
TABLE 239
Message level
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
Informational
1396
Syslog messages (Continued)
Message
Bridge root changed, vlan <vlan-id>, new
root ID <string>, root interface <portnum>
Bridge topology change, vlan <vlan-id>,
interface <portnum>, changed state to
<stp-state>
Cold start
DHCP : snooping on untrusted port
<portnum>, type <number>, drop
DOT1X : port <portnum> - mac <mac
address> Cannot apply an ACL or MAC filter
on a port member of a VE (virtual interface)
DOT1X : port <portnum> - mac <mac
address> cannot remove inbound ACL
DOT1X : port <portnum> - mac <mac
address> Downloading a MAC filter, but MAC
filter have no effect on router port
DOT1X : port <portnum> - mac <mac
address> Downloading an IP ACL, but IP ACL
have no effect on a switch port
DOT1X : port <portnum> - mac <mac
address> Error - could not add all MAC filters
DOT1X : port <portnum> - mac <mac
address> Invalid MAC filter ID - this ID
doesn't exist
DOT1X : port <portnum> - mac <mac
address> Invalid MAC filter ID - this ID is user
defined and cannot be used
Explanation
A Spanning Tree Protocol (STP) topology
change has occurred.
The <vlan-id> is the ID of the VLAN in which
the STP topology change occurred.
The <root-id> is the STP bridge root ID.
The <portnum> is the number of the port
connected to the new root bridge.
A Spanning Tree Protocol (STP) topology
change has occurred on a port.
The <vlan-id> is the ID of the VLAN in which
the STP topology change occurred.
The <portnum> is the port number.
The <stp-state> is the new STP state and
can be one of the following:
•
disabled
•
blocking
•
listening
•
learning
•
forwarding
•
unknown
The device has been powered on.
The device has indicated that the DHCP
client receives DHCP server reply packets
on untrusted ports, and packets are
dropped.
The RADIUS server returned an IP ACL or
MAC address filter, but the port is a
member of a virtual interface (VE).
An error occurred while removing the
inbound ACL.
The RADIUS server returned an MAC
address filter, but the <portnum> is a router
port (it has one or more IP addresses).
The RADIUS server returned an IP ACL, but
the <portnum> is a switch port (no IP
address).
The Dell PowerConnect device was unable
to implement the MAC address filters
returned by the RADIUS server.
The MAC address filter ID returned by the
RADIUS server does not exist in the Dell
PowerConnect configuration.
The port was assigned a MAC address filter
ID that had been dynamically created by
another user.
PowerConnect B-Series FCX Configuration Guide
53-1002266-01