Show Management Access-Class - Dell Networking 7048 Reference Manual

console(config)# management access-class mlist
The following example shows how to configure all the interfaces to be
management interfaces except for two interfaces, gigabit Ethernet 1/0/1 and
2/0/9.
console(config)# management access-list mlist
console(config-macal)# deny gigabitethernet 1/0/1 priority 1
console(config-macal)# deny gigabitethernet 2/0/9 priority 2
console(config-macal)# permit priority 2
console(config-macal)# exit
console(config)# management access-class mlist

show management access-class

Use the show management access-class command in Privileged EXEC mode
to display information about the active management access list.
Syntax
show management access-class
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Example
The following example displays the management access-list information.
console# show management access-class
Management access-class is enabled, using access list mlist
1477
Management ACL Commands