Sntp Server - Dell Networking 7048 Reference Manual

Default Configuration
The polling interval is 64 seconds.
Command Mode
Global Configuration mode
User Guidelines
If a user enters a value which is not an exact power of two, the nearest power-
of-two value is applied.
Example
The following example sets the polling time for the Simple Network Time
Protocol (SNTP) client to 1024 seconds.
console(config)# sntp client poll timer 1024

sntp server

Use the sntp server command in Global Configuration mode to configure an
SNTP server address or a host name. The server address can be either an IPv4
address or an IPv6 address. Use the no form of this command to unconfigure
an SNTP server address or a host name.
Syntax
ip-address
sntp server {
ip-address
no sntp server {
ip-address — IP address of the server.
•
hostname — Hostname of the server. (Range: 1-158 characters)
•
Parameter Description
This command does not require a parameter description.
Default Configuration
This command has no default configuration.
ipv6-address
| | hostname}
ipv6-address
| | hostname}
Clock Commands
1415