Passwords Strength Exclude-Keyword - Dell Networking 7048 Reference Manual

Default Behavior
The default value is 0. This limit is not enforced unless the passwords
strength minimum character-classes command is configured with a value
greater than 0.
Command Mode
Global Configuration
User Guidelines
This command is used to enable password character class checking using the
parameters set by the following commands:
• passwords strength minimum uppercase-letters
• passwords strength minimum lowercase-letters
• passwords strength minimum special-characters
• passwords strength minimum numeric-characters
A value greater than 0 specifies the minimum number of character class tests
a password must pass. A value of 0 disables the minimum strength checking
set by the above commands.
Example
console(config)#passwords strength minimum character-classes 4

passwords strength exclude-keyword

Use this command to exclude the keyword while configuring the password.
The password does not accept the keyword in any form (inbetween the string,
case insensitive and reverse) as a substring. You can configure up to a
maximum of three keywords. Use the no form of this command to reset the
restriction for a given string or all the strings configured.
Syntax
passwords strength exclude–keyword
no passwords strength exclude–keyword [
1496
Password Management Commands
string
string ]