Passwords Strength Max-Limit Repeated-Characters - Dell Networking 7048 Reference Manual

A maximum of 0 means there is no restriction on consecutive characters.
Examples of consecutive characters are ABCDEF or 123456 or !"#$%&'().
Use the no form of this command to reset the maximum consecutive
characters accepted to the default value.
Syntax
0–15
passwords strength max-limit consecutive–characters
no passwords strength max-limit consecutive-characters
Parameter Description
This command does not require parameter descriptions.
Default Behavior
The default value is 0.
Command Mode
Global Configuration
User Guidelines
This command has no user guidelines.
Example
console(config)#passwords strength max-limit consecutive-characters 3
passwords strength max-limit repeated-
characters
Use this command to enforce a maximum repeated characters that a
password should contain. If password has repetition of characters more than
the configured max-limit, it fails to configure. The valid range is 0-15. The
default is 0. A maximum of 0 means again disabling the restriction. Use the
no form of this command to reset the maximum repeated characters to the
default value.
1494
Password Management Commands