Hitachi XP P9500 User Manual page 548

Sun Cluster 3.2 Commands
Table A-1 Correspondence Between Sun Cluster 3.1 Commands and Sun
Cluster 3.2 Commands on page A-2
Sun Cluster 3.1 commands and Sun Cluster 3.2 commands. For details about
the command options, see the documentation for Sun Cluster 3.2.
#
Note that there are no differences between Sun Cluster 3.2 commands
and Oracle Solaris Cluster 3.3 commands.
Table A-1 Correspondence Between Sun Cluster 3.1 Commands and Sun
scconf -a -q globaldev=device-ID-of-the-
Quorum-device
scconf -c -q installmode
scconf -c -q node=node-name,maintstate
scconf -c -q node=node-name,reset
scconf -c -q reset
scconf -pv | grep Quorum
scconf -r -q globaldev=device-ID-of-the-
Quorum-device
scdidadm -C
scdidadm -L
scdidadm -l
scdidadm -r
scdidadm -ui
scgdevs
scsetup
scshutdown -g0 -y
scstat -q
scstat -D
A-2
Cluster 3.2 Commands
Commands for Sun Cluster 3.1
Sun Cluster 3.2 Commands
Hitachi Dynamic Link Manager User Guide (for Solaris(R))
shows the correspondence between
Commands for Sun Cluster 3.2
clquorum add device-ID-of-the-
Quorum-device
cluster set -p
installmode=enabled
clquorum disable -t node node-
name
• Change the mode of the node
from the maintenance mode to
the previous mode, and then
reset the quorum vote count.
clquorum enable -t node
node-name
•
Reset the quorum vote count
clquorum reset
clquorum reset
clquorum show
clquorum remove device-ID-of-the-
Quorum-device
cldevice clear
cldevice list -v
cldevice list -n node-name -v
cldevice refresh
scdidadm -ui
cldevice populate
clsetup
cluster shutdown -g0 -y
clquorum status
cldevicegroup status
#
#1
#2