Hitachi XP P9500 User Manual page 287

boot -r (at the ok prompt)
¢
20 Execute the dlnkmgr command's view operation specifying the -lu
.
parameter, and check that the configuration has changed.
21 If you are using Sun Cluster, remove the device ID information of devices
.
that do not exist. Execute the following command:
# /usr/cluster/bin/scdidadm -C
22 If you are using Sun Cluster, assign device IDs. Execute the following
.
command:
# /usr/cluster/bin/scdidadm -r
23 If you are using Sun Cluster, notify the server of the new device ID
.
information. Execute the following command:
# /usr/cluster/bin/scdidadm -ui
24 If you are using Sun Cluster, update the Sun Cluster global device
.
namespace. Execute the following command:
# /usr/cluster/bin/scgdevs
25 If you cleared the settings for a Quorum device in step 3, perform the
.
following procedure:
When using, as a Quorum device, an HDLM device of an LU newly
recognized for the first time by HDLM driver, set up the Quorum device on
any node in the cluster. The following shows an example of executing the
command:
Check the device ID of the HDLM device.
# /opt/DynamicLinkManager/bin/dlnkmgr view -path
# /usr/cluster/bin/scdidadm -L
Set up the Quorum device:
# /usr/cluster/bin/scconf -a -q globaldev=d4
For cluster configurations with two nodes, execute the following command
to clear the install mode for the cluster:
# /usr/cluster/bin/scconf -c -q reset
26 If you cleared the settings for a disk device group in step 5, perform
.
registration for the disk device group.
If you are using VxVM, see
If you are using SDS, see
Registering HDLM Devices on page
If you are using SVM, see
Registering HDLM Devices on page
27 Recreate any metadevices you deleted in step 8.
.
Hitachi Dynamic Link Manager User Guide (for Solaris(R))
Linking VxVM and Sun Cluster on page
To Use a Shared Diskset on page 3-158
3-157.
To Use a Shared Diskset on page 3-161
3-161.
HDLM Operation
3-154.
of
of
4-41