Adding A New Lu (When Not Using Sun Cluster) - Hitachi XP P9500 User Manual

• After you execute the dlmcfgmgr utility to add a new LU, when you
execute the path status display command (the view -path operation),
the HDevName of the added LU may be displayed as a hyphen (-).

Adding a New LU (When Not Using Sun Cluster)

To add a new LU:
1 Set up the storage system and switch so that Solaris recognizes the LU.
.
Specify the following settings to have Solaris recognize the newly added
LU:
¢
¢
¢
¢
For details on how to perform these settings, refer to the documentation
for the HBA being used. You may need to restart the host, depending on
the HBA being used, its drivers, and the path configuration of the newly
added LU.
2 Check the newly recognized LU.
.
You can check the LU by using the format command.
of executing the format command on page 4-24
executing the format command. The shaded portion represents the newly
recognized LU.
Storage system settings (to map the internal LU to the storage port
LUN)
Connection between the storage port and the host HBA port
Fibre Channel switch settings
Settings for the host HBA, and for the sd or ssd driver
HDLM Operation
Hitachi Dynamic Link Manager User Guide (for Solaris(R))
Figure 4-1 Example
shows an example of
4-23