Hitachi XP P9500 User Manual page 219
Hitachi dynamic link manager software user guide for solaris (6.6) (hit5205-96011, november 2011)
Hide thumbs
Also See for XP P9500:
- User manual (746 pages) ,
- User manual (188 pages) ,
- User manual (422 pages)
Table of Contents
Advertisement
4
Verify that the VxVM disk group has been imported into only one of the
.
nodes that constitute a cluster.
If the VxVM disk group has been deported from all nodes, import the
VxVM disk group to be registered in Sun Cluster into only one of the
nodes.
5
If the VxVM disk group is not registered in Sun Cluster, execute the
.
scsetup utility from the node into which you imported the VxVM disk
group to be registered in Sun Cluster, and then register the VxVM disk
group into a Sun Cluster disk device group.
For details, refer to the explanation of system administration in the Sun
Cluster documentation.
The following shows the procedure:
Start the scsetup utility.
¢
# /usr/cluster/bin/scsetup
The Main Menu appears.
Enter 5 (Device group and volumes) to perform operations on the
¢
VxVM disk device group.
The Device Group Menu appears.
Enter 1 (Register a VxVM disk group as a device group) to register the
¢
VxVM disk device group.
Following the prompts, specify the VxVM disk group name to be
registered as a Sun Cluster disk device group, the priority level of the
master node, and whether or not to perform switchback.
Note
After you enter this information, the following message may be output
to syslog:
KAPL05023-E Could not process the IOCTL(00004D03).
(00000000:00000000)
Even if this message is output to syslog, no problems exist
operationally, provided that the Status of the device group newly
registered in the following step is Online.
Confirm that the disk device group is registered, and that its Status is
¢
Online.
If the disk device group was registered appropriately, use of the
following command will display information about the new disk device
group:
# /usr/cluster/bin/scstat -D
Note
After registering the VxVM disk group into a Sun Cluster disk device
group, do not use the VxVM command to import or deport that VxVM
disk group.
If you register the VxVM disk group into a Sun Cluster disk device
group where more than 3 nodes are configured, the following
message might appear when changing the node that acts as the
master for the disk group. If this message appears, ignore it.
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Solaris(R))
3-155
Advertisement
Table of Contents
