Setting Up Vxvm - Hitachi XP P9500 User Manual

Execute a command such as the following:
# mount -F ufs /dev/dsk/c2t7d16s0 mount-point
4 Enable automatic mounting.
.
To automatically mount the HDLM-managed device when the host starts,
edit the /etc/vfstab file.
Execute the following command to display the current setting:
# mount -p
Figure 3-20 An output example for the mount -p command on page 3-136
shows an output example of the command.
Edit the /etc/vfstab file as appropriate based on the settings output.
The shaded portion indicates the part of the /etc/vfstab file to set.
An example of how to edit the /etc/vfstab file is shown below in
3-21 An example of how to edit the /etc/vfstab file on page
Add the shaded portion to the file.

Setting Up VxVM

When you are using VxVM, VxVM accesses an LU by using an HDLM device.
VxVM will automatically recognize HDLM devices. Perform setup as you would
for any other device, by following the VxVM documentation.
3-136
Figure 3-20 An output example for the mount -p command
Figure 3-21 An example of how to edit the /etc/vfstab file
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Solaris(R))
Figure
3-136.