Hitachi XP P9500 User Manual page 156

• Two LUs have the same capacity as the local boot disk need to be created
in the storage system. You also need to configure at least one data disk
on the host.
• If HDLM has already been installed, remove either of the two LUs created
in the storage system from HDLM management. Set the other LU as an
HDLM-managed device.
In the procedure below, the LU removed from HDLM management is
referred to as LU#0, and the LU set as the HDLM-managed device is
referred to as LU#1.
To change the HDLM-managed device to a device not managed by HDLM,
see
New Installation of HDLM on page
1 Set the disk slices for LU#0 and LU#1.
.
Set the disk slices for an LU as follows:
¢
¢
Other slices are not used.
2 Execute the zpool create command to create a root pool on the SCSI
.
device.
# zpool create root-pool-name slide-0-of-LU-SCSI-device
In the following example, the root pool name is rpoo12 and the SCSI
device name for the LU is c2t50060E8010253334d0.
# zpool create rpoo12 c2t50060E8010253334d0s0
3 Execute the zpool status command and make sure that the root pool
.
has been created correctly.
# zpool status
pool: rpool2
state: ONLINE
scrub: none requested
config:
NAME
rpool2
c2t50060E8010253334d0s0
errors: No known data errors
4 Execute the lucreate command to copy the local boot disk environment
.
to LU#0.
# lucreate -n new-boot-environment-name -p root-pool-name
In the following example, the boot disk environment name is zfsBE, and
the root pool name is rpool2.
# lucreate -n zfsBE -p rpool2
When the command terminates normally, the boot disk has been copied
to rpool2.
5 Execute the lustatus command to check the copied ZFS boot disk
.
environment.
3-92
Using the HDLM Device Unconfiguration Function When Performing a
Slice 0: All disk areas are allocated.
Slice 2: All disk areas are allocated.
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Solaris(R))
3-66.
STATE READ
ONLINE 0
ONLINE 0
WRITE CKSUM
0 0
0 0