3
Set the LU slices to be used by the post-migration boot disk.
.
4
Complete the preparations for installing HDLM in the pre-migration
.
environment and then install HDLM, referring to the description in
Installing HDLM on page
Perform the necessary steps.
Note
After you finish these steps, perform the procedure described in
Up the Post-Migration Environment on page
Migration by Installing HDLM in the Existing Boot Disk Environment
Perform the following steps in the pre-migration environment. The workflow
is shown in
using an existing boot disk environment without HDLM installed as the pre-
migration environment on page
Do not exclude the post-migration boot disk from HDLM management
when you set the devices to be excluded in step 11 of
New Installation of HDLM (When Sun Cluster Is Not Being Used) on
page 3-49
or in step 17 of
(When Sun Cluster Is Being Used) on page
Figure 3-10 Flow of setting up the boot disk environment when
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Solaris(R))
3-41.
Performing a New Installation of HDLM
3-85.
3-82.
Performing a
3-56.
Setting
3-81