Hitachi XP P9500 User Manual page 126

If the nodes were started in cluster mode, execute the following
command on any one node:
# /usr/cluster/bin/scshutdown -g0 -y
20 With the reconfiguration option specified, start all nodes comprising the
.
cluster in cluster mode, at the same time.
Execute boot -r at the ok prompt.
Note
21 Execute the dlnkmgr command's view operation on all nodes comprising
.
the cluster to display the status of the programs.
The following shows an example of executing the command:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys
HDLM Version
Service Pack Version
Load Balance
Support Cluster
Elog Level
Elog File Size (KB)
Number Of Elog Files
Trace Level
Trace File Size(KB)
Number Of Trace Files
Path Health Checking
Auto Failback
Intermittent Error Monitor
HDLM Manager Ver
Alive
HDLM Alert Driver Ver
Alive
HDLM Driver Ver
Alive
License Type Expiration
Permanent
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time = yyyy/mm/dd hh:mm:ss
#
Nothing is displayed for Support Cluster even if you are using cluster
software. However, the cluster-support functions are, in fact, operating
without problem.
3-62
While a node is starting, the message below may be output to the
console or syslog:
Could not read symbolic link for: /dev/rdsk/c5t0d0s2 path not
loaded
This message is output because HDLM deleted the logical device file of
an sd or ssd device managed by HDLM. Perform the procedure for
updating the device ID information (steps 27 to 30) so that this
message is not output the next time the node starts. For details, refer
to the Sun Cluster documentation.
x.x.x-xx
x.x.x-xx
WakeupTime
x.x.x-xx
-
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Solaris(R))
: x.x.x-xx
:
: on(extended lio)
:
: 3
: 9900
: 2
: 0
: 1000
: 4
: on(30)
: on(1)
: off
WakeupTime
yyyy/mm/dd hh:mm:ss
WakeupTime
yyyy/mm/dd hh:mm:ss 4096
yyyy/mm/dd hh:mm:ss
ElogMem Size