Stp Port Settings - D-Link Dis-200G Series Web Ui Reference Manual

Click the Apply button to accept the changes made.
The fields that can be configured for BPDU Forward are described below:
Parameter
BPDU Forward
Click the Apply button to accept the changes made.

STP Port Settings

This window is used to view and configure the STP port settings.
To view the following window, click L2 Features > Spanning Tree > STP Port Settings, as shown below:
The fields that can be configured are described below:
Parameter
From Port / To Port
Port Fast
Click the Apply button to accept the changes made.
DIS-200G Series Industrial Gigabit Ethernet Smart Managed Switch
Description
Select to enable or disable BPDU forwarding. If enabled, the
received STP BPDU will be forwarded to all VLAN member ports in
the untagged form. By default, this option is Disabled.
Figure 6-36 STP Port Settings window
Description
Select the appropriate port range used for the configuration here.
Select the port fast option here. Options to choose from are
Network, Disabled, and Edge. In the Network mode, the port will
remain in the non-port-fast state for three seconds. The port will
change to the port-fast state if no BPDU is received and changes
to the forwarding state. If the port received the BPDU later, it will
change to the non-port-fast state. In the Disabled mode, the port
will always be in the non-port-fast state. It will always wait for the
forward-time delay to change to the forwarding state. In the Edge
mode, the port will directly change to the spanning-tree forwarding
state when a link-up occurs without waiting for the forward-time
delay. If the interface receives a BPDU later, its operation state
changes to the non-port-fast state. By default, this option is
Network.
70