Ipv4 Static/Default Route - D-Link DGS-3630 Series Reference Manual

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
Parameter
Click the Apply button to accept the changes made.
The fields that can be configured for Static IPv6 Address Settings are described below:
Parameter
IPv6 Address
Click the Apply button to accept the changes made.
After selecting the Interface IPv6 Address tab option, at the top of the page, the following page will be available.
Click the Delete button to delete the specified entry.

IPv4 Static/Default Route

This window is used to display and configure the default IPv4 route settings.
To view the following window, click L3 Features > IPv4 Static/Default Route, as shown below:
The fields that can be configured are described below:
Parameter
IP Address
Mask
Description
Select the Default option to specify that if the default router is selected on this
interface, a default route will be installed using that default router. This option
can only be specified on one interface.
Description
Enter the IPv6 address for this IPv6 interface here. Select the EUI-64 option to
configure an IPv6 address on the interface using the EUI-64 interface ID. Select
the Link Local option to configure a link-local address for the IPv6 interface.
Figure 6-9 IPv6 Interface (Detail, Interface IPv6 Address) Window
Figure 6-10 IPv4 Static/Default Route Window
Description
This field cannot be configured in the OpenFlow mode.
Only the Default Route is supported.
This field cannot be configured in the OpenFlow mode.
78