(Port) Interface Configuration - Comtrol RocketLinx ES7528 User Manual

Feature Configuration

(Port) Interface Configuration

Type interface IFNAME in global configuration mode. You can then enter Interface Configuration mode. In this mode, you
can configure port settings.
The port interface name for Fast Ethernet port 1 is fa1, Fast Ethernet 7 is fa7, gigabit Ethernet Port 25 is gi25 gigabit Ethernet
Port 28 is gi28. Type the interface name accordingly, when you want to enter certain interface configuration mode.
Type exit to leave.
Type ? to see the command list
Available command lists of the Port Interface Configuration mode.
Switch(config)# interface fa1
Switch(config-if)#
acceptable
auto-negotiation
description
dot1x
duplex
end
exit
flowcontrol
garp
ingress
ip
lacp
list
loopback
mac
mdix
no
poe
qos
quit
rate-limit
sfp
shutdown
spanning-tree
speed
storm-control
switchport
26 - RocketLinx ES7528 Industrial Managed PoE Rack Mount User Guide: 2000509 Rev. A
Configure 802.1Q acceptable frame types of a port
Enable auto-negotiation state of a given port
Interface specific description
IEEE 802.1x standard access security control
Specify duplex mode of operation for a port
End current mode and change to enable mode
Exit current mode and down to previous mode
Set flow-control value for an interface
General Attribute Registration Protocol
802.1Q ingress filtering features
Interface Internet Protocol config commands
Link Aggregation Control Protocol
Print command list
Specify loopback mode of operation for a port
MAC interface commands
Enable mdix state of a given port
Negate a command or set its defaults
Configure Power over Ethernet
Quality of Service (QoS)
Exit current mode and down to previous mode
Rate limit configuration
Small form-factor pluggable
Shutdown the selected interface
spanning-tree protocol
Specify the speed of a Fast Ethernet port
Enables packet flooding rate limiting features
Set switching mode characteristics
(Port) Interface Configuration