Table of Contents
Advertisement
(Port) Interface Configuration
When you type interface IFNAME in Global Configuration mode, you can access Interface Configuration mode.
In this mode you can configure port settings.
The port interface names for Gigabit Ethernet port are gi1 through gi9.Type the following commands and
press the Enter key:
•
exit to return to Privileged EXEC mode.
•
? to see the command list.
•
list to review the Interface Configuration mode commands and corresponding options. The following list is
the available commands for the Port Interface Configuration mode.
For the complete list of commands and options, refer to
Switch(config)# interface gi1
Switch(config-if)#
acceptable
auto-negotiation
description
dot1x
duplex
end
exit
flowcontrol
garp
ingress
lacp
list
loopback
mdix
mtu
no
qos
quit
rate-limit
sfp
shutdown
spanning-tree
speed
switchport
RocketLinx ES8509-XT User Guide: 2000557 Rev. D
Configure 802.1Q acceptable frame types of a port
Enable auto-negotiation state of a given port
Interface specific description
IEEE 802.1x standard access security control
Specify duplex mode of operation for a port
End current mode and change to enable mode
Exit current mode and down to previous mode
Set flow-control value for an interface
General Attribute Registration Protocol
IEEE 802.1Q ingress filtering features
Link Aggregation Control Protocol
Print command list
Specify loopback mode of operation for a port
Enable mdix state of a given port
Specifies the MTU on a port
Negate a command or set its defaults
Quality of Service (QoS)
Exit current mode and down to previous mode
Rate limit configuration
Small form-factor pluggable
Shutdown the selected interface
spanning-tree protocol
Specify the speed of a Fast Ethernet port or a
Gigabit Ethernet port
Set switching mode characteristics
Configuration Using the Command Line Interface (CLI)
Port Interface Configuration Mode
(Port) Interface Configuration - 139
on Page 196.
Advertisement
Table of Contents
