Table of Contents
Advertisement
Configuration Using the Command Line Interface (CLI)
(Port) Interface Configuration
When you type interface IFNAME in Global Configuration mode, you can access Interface Configuration mode.
In this mode you can configure port settings.
The port interface names for the Fast Ethernet ports are fa1 through fa6
Type the following commands and press the Enter key:
•
exit to return to Privileged EXEC mode.
•
? to see the command list.
•
list to review the Interface Configuration mode commands and corresponding options. The following list is
the available commands for the Port Interface Configuration mode.
For the complete list of commands and options, refer to
Switch(config)# interface fa1
Switch(config-if)#
auto-negotiation
description
duplex
end
exit
flowcontrol
list
loopback
mac
mdix
no
poe
qos
quit
rate-limit
shutdown
spanning-tree
speed
switchport
104 - (Port) Interface Configuration
Enable auto-negotiation state of a given port
Interface specific description
Specify duplex mode of operation for a port
End current mode and change to enable mode
Exit current mode and down to previous mode
Set flow-control value for an interface
Print command list
Specify loopback mode of operation for a port
MAC interface commands
Enable mdix state of a given port
Negate a command or set its defaults
Configure Power over Ethernet
Quality of Service (QoS)
Exit current mode and down to previous mode
Rate limit configuration
Shutdown the selected interface
spanning-tree protocol
Specify the speed of a Fast Ethernet port
Set switching mode characteristics
Port Interface Configuration Mode
RocketLinx ES7506 User Guide: 2000529 Rev. F
on Page 155.
Advertisement
Table of Contents
