Comtrol RocketLinx ES7528 User Manual page 56

Command Lines for Port Configuration
Rate Control
Rate Control –
Switch(config-if)# rate-limit
Ingress or
egress
Egress
ingress
Note: To enable rate control, you should select the Ingress or Egress rule first; then assign the packet type
and bandwidth.
Rate Control –
Switch(config-if)# rate-limit ingress mode
Filter Packet
all
Type
broadcast
flooded-unicast
multicast
Switch(config-if)# rate-limit ingress mode broadcast
Set the ingress limit mode broadcast ok.
Rate Control –
Switch(config-if)# rate-limit ingress bandwidth
Bandwidth
<0-100>
Switch(config-if)# rate-limit ingress bandwidth 8
Set the ingress rate limit 8Mbps for Port 1.
Storm Control
Storm Control
Switch(config-if)# storm-control
– Packet Type
broadcast :Broadcast packets
dlf :Destination Lookup Failure
multicast :Multicast packets
Storm Control
Switch(config)# storm-control broadcast
- Rate
<0-100000> Rate limit value 0~262143 packet/sec
Switch(config)# storm-control broadcast 10000
limit_rate = 10000 packets/sec
Set rate limit for Broadcast packets.
Switch(config)# storm-control multicast 10000
limit_rate = 10000 packets/sec
Set rate limit for Multicast packets.
Switch(config)# storm-control dlf 10000
limit_rate = 10000 packets/sec
Set rate limit for Destination Lookup Failure packets.
Port Trunking
LACP
Switch(config)# lacp group 1 25-28
Group 1 based on LACP(802.3ad) is enabled!
Note: The interface list is fa1,fa3-5, and gi25-28. Ports with a different speeds cannot be aggregated
together.
Static Trunk
Switch(config)# trunk group 2 fa6-7
Trunk group 2 enable ok!
56 - RocketLinx ES7528 Industrial Managed PoE Rack Mount User Guide: 2000509 Rev. A
Outgoing packets
Incoming packets
Limit all frames
Limit Broadcast frames
Limit Broadcast, Multicast and flooded unicast frames
Limit Broadcast and Multicast frames
Limit in megabits per second (0 is no limit)
Command Lines for Port Configuration