Comtrol RocketLinx ES7528 User Manual page 86

CLI Commands for the VLAN
VLAN Port Configuration (continued)
Display – Port Egress
Switch# show running-config
Rule (Egress rule, IP
......
address, status)
!
interface fastethernet1
.......
interface vlan1
VLAN Configuration
Create VLAN (2)
Switch(config)# vlan 2
vlan 2 success
Switch(config)# interface vlan 2
Switch(config-if)#
Note: In the CLI configuration, you should first create a VLAN interface. Then you can start to
Remove VLAN
Switch(config)# no vlan 2
no vlan success
Note: You can only remove the VLAN when the VLAN is in unused mode.
VLAN Name
Switch(config)# vlan 2
vlan 2 has exists
Switch(config-vlan)# name v2
Switch(config-vlan)# no name
Note: Use no name to change the name to default name, VLAN VID.
VLAN description
Switch(config)# interface vlan 2
Switch(config-if)#
Switch(config-if)# description this is the VLAN 2
Switch(config-if)# no description
IP address of the
Switch(config)# interface vlan 2
VLAN
Switch(config-if)#
Switch(config-if)# ip address 192.168.250.18/24
Switch(config-if)# no ip address 192.168.250.8/24
address
Create multiple
Switch(config)# interface vlan 5-10
VLANs (VLAN 5-10)
Shut down VLAN
Switch(config)# interface vlan 2
Switch(config-if)# shutdown
Switch(config-if)# no shutdown
86 - RocketLinx ES7528 Industrial Managed PoE Rack Mount User Guide: 2000509 Rev. A
switchport access vlan 1
switchport access vlan 3
switchport trunk native vlan 2
ip address 192.168.250.8/24
no shutdown
add/remove ports. The default status of the created VLAN is unused until you add member
ports to it.
->Delete the description.
->Turn on the VLAN
CLI Commands for the VLAN
->Delete the IP