Comtrol RocketLinx ES7528 User Manual page 87

VLAN Configuration (continued)
Display – VLAN table Switch# sh vlan
VLAN Name
---- ----
1
2
3
Display – VLAN
Switch# show interface vlan1
interface information
interface vlan1 is up, line protocol detection is disabled
missed 0
window 0
GVRP Configuration
GVRP enable/disable
Switch(config)# gvrp mode
Switch(config)# gvrp mode enable
Gvrp is enabled on the switch!
Configure GVRP timer
Switch(config)# inter fa1
Switch(config-if)# garp timer
Join timer /Leave
Switch(config-if)# garp timer 20 60 1000
timer/ LeaveAll timer
Note: The unit of this timer is centiseconds.
Management VLAN
Management VLAN
Switch(config)# int vlan 1 (Go to management VLAN)
Switch(config-if)# no shutdown
Display
Switch# show running-config
....
!
interface vlan1
!
....
CLI Commands for the VLAN
Status
------
VLAN1 Static
VLAN2 Unused
test Static
index 14 metric 1 mtu 1500 <UP,BROADCAST,RUNNING,MULTICAST>
HWaddr: 00:c0:4e:ff:01:b0
inet 192.168.250.100/24 broadcast 192.168.250.255
input packets 639, bytes 38248, dropped 0, multicast packets 0
input errors 0, length 0, overrun 0, CRC 0, frame 0, fifo 0,
output packets 959, bytes 829280, dropped 0
output errors 0, aborted 0, carrier 0, fifo 0, heartbeat 0,
collisions 0
disable Disable GVRP feature globally on the switch
enable Enable GVRP feature globally on the switch
<10-10000>
ip address 192.168.250.17/24
ip igmp
no shutdown
RocketLinx ES7528 Industrial Managed PoE Rack Mount User Guide: 2000509 Rev. A - 87
Trunk Ports
------------ --------------------------
-
-
fa4-7,gi25-28 fa1-3,fa7,gi25-28
CLI Commands for the VLAN
Access Ports
fa1-7,gi25-28
-