Factory Defaults - Comtrol RocketLinx ES7528 User Manual

Factory Defaults

This represents a firmware upgrade in TFTP server mode.
After finishing transmitting the firmware, the system copies the firmware file and replace the firmware in the flash. The CLI
show ...... until the process is finished.
Factory Defaults
You can reset all the configurations of the switch to default settings.
Click Reset, if you want the ES7528 to reset
all configurations to factory default settings.
The system displays a popup message
window after finishing this command. The
default settings work after rebooting the
RocketLinx ES7528.
Click Yes in the popup alert screen to reset
the configuration to the factory defaults.
The following popup message screen shows you that the RocketLinx ES7528 has been reset to factory defaults. Click OK to
close the screen and then go to the Reboot page to reboot the switch.
Click OK. The system automatically reboots the ES7528.
Note: If you have already configured the IP of your ES7528 to another IP address, when you use this command with the CLI
and web interface, the software does not reset the IP address to the default IP address. The RocketLinx ES7528 IP
address does not change so that you can still connect the switch through the network.
40 - RocketLinx ES7528 Industrial Managed PoE Rack Mount User Guide: 2000509 Rev. A
Factory Defaults