Comtrol RocketLinx ES7528 User Manual page 121

System Event
Device Cold Start
Device Warm Start
Authentication failure
Time Synchronize Failure
Fault Relay
Super Ring Topology
Changes
SFP DDM Failure
Power Failure
Port Event
Link-Up
Link-Down
Both
PoE Powering Event
Enable
Disable
Apply
Event Selection
Warning Event is sent when....
Power is cut off and then reconnected.
Reboot the device by CLI or Web UI.
An incorrect password, SNMP Community String is entered.
Accessing the NTP Server is failing.
The DO/Fault Relay is on.
Master of Super Ring has changed or backup path is activated.
The information read from the DDM SFP transceiver is over
temperature or out the range of TX/RX power.
Power (AC, DC1, DC2 or Any) is failure.
Warning Event is sent when.....
The port is connected to another device
The port is disconnected (e.g. the cable is pulled out, or the
opposing devices turns down)
The link status changed.
Warning Event is sent when.....
The PoE port is powering.
The PoE port is not powering.
Click Apply to apply the settings.
Note: You must Save the settings (Page 137), if you want to
maintain these settings if the RocketLinx ES7528 is
powered off.
RocketLinx ES7528 Industrial Managed PoE Rack Mount User Guide: 2000509 Rev. A - 121
Event Selection