Cli Commands For The Vlan - Comtrol RocketLinx ES7528 User Manual

CLI Commands for the VLAN

The following table provides detailed information about command lines for VLAN port configuration, VLAN configuration,
and VLAN table display.
Feature
VLAN Port Configuration
VLAN Port PVID
Switch(config-if)# switchport trunk native vlan 2
Set port default vlan id to 2 success
Port Accept Frame
Switch(config)# inter fa1
Type
Switch(config-if)# acceptable frame type all
any kind of frame type is accepted!
Switch(config-if)# acceptable frame type vlantaggedonly
only vlan-tag frame is accepted!
Ingress Filtering (for
Switch(config)# interface fa1
Fast Ethernet Port 1)
Switch(config-if)# ingress filtering enable
ingress filtering enable
Switch(config-if)# ingress filtering disable
ingress filtering disable
Egress rule – Untagged
Switch(config-if)# switchport access vlan 2
(for VLAN 2)
switchport access vlan - success
Egress rule – Tagged
Switch(config-if)# switchport trunk allowed vlan add 2
(for VLAN 2)
Display – Port Ingress
Switch# show interface fa1
Rule (PVID, Ingress
Interface fastethernet1
Filtering, Acceptable
Frame Type)
CLI Commands for the VLAN
Administrative Status : Enable
Operating Status : Not Connected
Duplex : Auto
Speed : Auto
Flow Control :off
Default Port VLAN ID: 2
Ingress Filtering : Disabled
Acceptable Frame Type : All
Port Security : Disabled
Auto Negotiation : Enable
Loopback Mode : None
STP Status: disabled
Default CoS Value for untagged packets is 0.
Mdix mode is Auto.
Medium mode is Copper.
RocketLinx ES7528 Industrial Managed PoE Rack Mount User Guide: 2000509 Rev. A - 85
Command Line
CLI Commands for the VLAN