Configuring Mpls Lsps For Gmpls (Nsm Procedure); Table 153: Install Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1 Manual

Copyright © 2010, Juniper Networks, Inc.

Table 153: Install Configuration Details

Task
Associate one or more
prefixes with an LSP.

Configuring MPLS LSPs for GMPLS (NSM Procedure)

To enable the proper GMPLS switching parameters you can use the Lsp Attributes option.
To configure the LSP attributes in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Protocols > Mpls.
3.
Select Label Switched Path.
4.
Add or modify settings as specified in Table 154 on page 296.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Your Action
1. Click Add new entry next to Label Switched Path.
2. Click Install next to label-switched-path.
3. Click Add new entry next to Install.
4. In the Name box, enter the routing table.
5. In the Comment box, enter the comment.
6. Select the Active check box to install the route into the inet.0
routing table. This allows you to issue a ping or traceroute
command on this address.
Chapter 20: Configuring Protocols
295